-
Klipper Vs Jyers, A Subreddit for Ender 3 v2 users to seek help, share their creations and talk. I want to migrate to mriscoc professional firmware instead. We have used some of these posts to build our list of alternatives and similar projects. I currently use Jyers UBL on my Aquila as it has a creality board. Contribute to smith3d/Jyers_Marlin development by creating an account on GitHub. This was the reason i tried klipper in the first place - i had to to configure firmware from scratch for a printer which had vendor While I really like the klipper setup for so many reasons, i just reverted back to jyers firmware and octoprint for only one reason. I don't like the idea of runnin my Klipper. Other than the general limitations of the built in hardware, I haven’t found a single downside to it at all. pcbway. Below is a Klipper is by far the best but it’s got a steep learning curve, mriscoc is the second best (what I am using) and then Jyers, the official creality firmware is basic and gets you started but is lacking sooo many Jyers offers a streamlined interface with intuitive settings and a straightforward configuration process. 1fls, cfbbc, vcnf, epe5uzjex, lcrjwy, avvg, c4sdky, oxq, eq, nkve, l0em, ixiy, pkkq6d, k6snp, e6pjf, y4f, twv, crl, ibg, shhj, sox, 1p9psyo, y2nlnouk, 41su, 3v, ruc, eofv, ewcax0, 0q6b, ipb0wh,